Improving Own Computer

If your PC often show a lawyer-alamatan complex, or displays an error message, a beep sounds continuously uniformly or irregularly, the PC is probably in trouble, I will provide tips and solutions to overcome these problems and the PC You can serve again as usual.If your PC often show a lawyer-alamatan complex, or displays an error message, a beep sounds continuously uniformly or irregularly, the PC is probably in trouble, I will provide tips and solutions to overcome these problems and the PC You can serve again as usual.

Problems or damage arising usually categorized in 2 types of damage are: Problems or damage to hardware and software.

Damage Type Can be categorized into 2 categories, namely:

1. Damage to the Hardware (Hardware)

2. Damage to the Software (Software)

Damage to the Hardware (Hardware)

Problems with hardware components which need serious treatment because it is difficult localized and removed without the proper tools, skills and experience that support. The explanation will revolve around the problems that often occur along with how to handle it.Problems with hardware components which need serious treatment because it is difficult localized and removed without the proper tools, skills and experience that support. The explanation will revolve around the problems that often occur along with how to handle it.

Damage to the Power Supply

Symptoms:

Once turned on the PC does not react to anything, there is no display on the monitor, there is no indicator light (LED) is lit, power supply fan is not spinning, the indicator light on the monitor is not lit.

Solution:

Check whether the cable is properly connected and properly installed the plug on soketnya, also check that there is the on / off behind exactly behind the Power Supply is in the On position, If you are sure it locks into place, but still no response to assure you please replace the power cable with which you believe in good. Problems occur because of the lack of incoming voltage, there is damage to the power cable.

Problem:

Once turned on the PC does not react to anything, there is no display on the monitor, there is no indicator light (LED) is lit, power supply fan is not spinning, the indicator light on the monitor.

Solution:

Proceed as above step, but if there was still no response means there is a problem in Power Supply, PS Please change it, I suggest you should just replace the damaged Power Supply with a new one, and be careful in the installation.

Note: If the damage is only on the Power Supply alone, When you replace it, the computer will return to work normally. Unless there is a problem in other components such as the Mother Board, VGA Card and Memory.

Damage to the Mother Board

Symptoms:

Once turned on, no display on the monitor, the indicator light (led) on the front panel is lit, the indicator light (led) flashing monitors, power supply fan and processor fan spin, no beep sound on the speakers.

Solution:

The first step off all power cables are connected to the electrical, data cable to the monitor, cable keyboad / mouse, and all cables are connected to the CPU, then screw the cover off all cashing. In an open case please also remove other components, namely cable from the power supply voltage is connected to the motherboard, hard drive, floppy, be careful in the process do not rush. Likewise with the card attached to the Mboard (VGA, Sound or Other Card). Now attached to the motherboard just cashing it. Please check carefully Motherboadnya, see Chip (IC), Elko, transistor and others if there is a fire.Solution:

The first step off all power cables are connected to the electrical, data cable to the monitor, cable keyboad / mouse, and all cables are connected to the CPU, then screw the cover off all cashing. In an open case please also remove other components, namely cable from the power supply voltage is connected to the motherboard, hard drive, floppy, be careful in the process do not rush. Likewise with the card attached to the Mboard (VGA, Sound or Other Card). Now attached to the motherboard just cashing it. Please check carefully Motherboadnya, see Chip (IC), Elko, transistor and others if there is a fire.

If there are no signs of burnt components motherboard is still good possibility, but there are times when Mother board is not working because of damage to the programs contained in the BIOS

Symptoms:

At the time of the CPU and then switched to the post after that the process does not continue and was silent for a moment did not directly go to the operating system, and then the screen is the message 'disk error, disk Failur, after it appeared the message "press F1 to continou" after we pressing the F1 key does not enter operating system and appears the message "Operating system not found".

Damage to the Hard Disk

Solution:

Check voltage cables and data cables into the hard drive is loose, should be tightened, then switch it on and let you listen to what came out of a normal hard disk, if not normal means controllernya damaged hard drive.

Symptoms:

At the time the CPU and then switched to the Post after it appeared the message "Operating system not found".

Solution:

Operating system there is the possibility of damage, can be overcome by installing OS ualng or if you are using windows 2000/XP there Repairnya facilities. or there is possibility also to your hard disk is not detected and do the above

Symptoms:

hard disk bad sector?

Solution:

There are several factors that cause bad sectors occurred among them, the voltage is unstable, often decided in a sudden flow of electricity, after the use is not in the shot down, consumption is too long, there are 2 kinds of bad sector physical and software ... .. To fix this there several ways, including using software to remove badsector .... Further discussion on eBooks and computer repair method can be found if you join the Active Member.

Type of damage is commonly encountered:

1. Not detected in windows

2. Can not get out in CD

3. Can not read / write / can only read it. (CD)

4. Can not read / write / write protect (floppy disk)

Solution:

1. Check the data cable and voltage cable into the CD-floppy, check it in bios setup if it is detected? should be set to auto. Check that the led is lit, if not damage the Controllernya.

2. Mechanical damage on the rubber motor or motors.

3. Usually the optical damage, but there may still be improved in a way to re-set the optics.

4. Gross Head, can be cleaned using Cutenbud (above steps are complete can be found in e-book "method of computer repair fast and accurate" and what you get if you join a member perbaikankomputer.com

BIOS problem

Symptoms:

Be careful in Bios Update, as he got the wrong update your BIOS version, the PC so no way you can not even enter the BIOS.

Solution:

Update usually can not be undone, only a certain type of motherboard that has a backup BIOS chip it in, there is saved the original BIOS types that can not be removed, for it can restore your stay special Jumper Position move that usually have no clue in the manuals. Then hidupka PC and wait 10 seconds, the original BIOS on Restore, restore Jumper position on the starting position, and the PC is ready to run again. If the motherboard does not have the pasilitas, the BIOS chip should be sent to the manufacturer, type your BIOS can see in the manuals. Careful not to install the BIOS IC legs broken or inverted position.

Symptoms:

CPU Beep sound in the speaker several times and no display to the screen, when the monitor is not a problem.

Solution:

Beep Beep indicates a specific error message from the BIOS, it shows the type of noise what went wrong on the PC, usually an error on a non-detectable Memory, VGA Card, which is not installed properly, even Processor Monitor data cable can be your penyebabnya.Silahkan check the problem.Symptoms:

CPU Beep sound in the speaker several times and no display to the screen, when the monitor is not a problem.

Solution:

Beep Beep indicates a specific error message from the BIOS, it shows the type of noise what went wrong on the PC, usually an error on a non-detectable Memory, VGA Card, which is not installed properly, even Processor Monitor data cable can be the cause. Please check the problem.

The following BIOS error message:

BIOS Beep error is usually not all. Motherboard indicates the same error depending on the type of its BIOS.

[AMI BIOS]

Beep 1x: RAM / Memory is not connected with the Fine or Damage, Beep 6x: Gate A20 error - Keyboard Showing damaged or IC-A20 Gate itself, Beep 8x: Grapihic Card / VGA Card is not installed properly or Damage, Beep 11x: checksum error, check the Bios Batre, and replace with new.

[AWARD BIOS]

1x Long beep: RAM / Memory is not connected with the Fine or Damage, 2x Long Beep 1x Short: Damage to the Graphic Card (VGA), can also check on the installation of slot does not fit (not entered), 1x Long Beep 3x Short: Keyboard broken or not installed. Beep No broken / continuous sound: RAM or Graphics Card not detected.

Damage Batrey CMOS / Weak

Symptoms: Appear message CMOS Checksum Vailure / Batrey Low, due to tegangna the IC supply CMOS / BIOS does not normally weak due batrey, thus setting the BIOS back to factory default Default-nya/setingan, and hardware configuration should be set back.

Solution: As soon as his Batrey Change

Symptoms: CPU is often Hang?

Solution: There are several factors such as hanging there: There BadSector in Hard, Some viruses, have a problem in hardware such as Memory Dirty / Damaged, Dirty MBoard / Damage, Cooling Fan fan rotation was already weak, unstable Power Supply ... .. should not be imposed to be used because it would result in more fatal, please hub: we are to overcome these problems

Symptoms: Computers often show what causes blue screen?

Solution: Blue Screen message can be caused by windows system is broken, Can of Memory, Can the hard disk, can be from other components, depending on the blue screen message is displayed.

Symptoms: Computers so more slowly than before, but not so slow at first

Solution: The cause your computer slow process there are several factors namely: disk space is too full, too many programs / software that consuming disk space and memory, there is a virus, hard drive badsector.